2009 BMW M6 Complete Service & Maintenance Schedule

Key Takeaways

• The 2009 BMW M6 is powered by the legendary S85 5.0L naturally aspirated V10 engine, producing 500 horsepower. This F1-derived engine demands a specific, diligent maintenance regimen due to its high-revving nature and known vulnerabilities.
• A mandatory break-in service is required at 1,200 miles, which includes replacement of the engine oil, transmission fluid, and differential fluid .
• Spark plugs must be replaced every 37,000 miles on this high-performance V10 engine .
• The S85 engine requires BMW-approved 10W-60 oil, which is critical for protecting the engine's bearings at high temperatures. Independent specialists recommend changing this oil every 5,000 miles for optimal protection .
• Oxygen sensors are due for replacement at 120,000 miles as per the factory schedule .
• Rod bearings are a known wear item on the S85 V10. Many specialists recommend proactive replacement between 60,000–80,000 miles .

Understanding the 2009 BMW M6 (E63/E64 Generation)

The 2009 BMW M6, offered as a coupe (E63) and convertible (E64), is powered by the legendary S85B50 5.0L naturally aspirated V10 engine. This engine is a milestone in BMW's history, derived from Formula 1 technology and producing 500 horsepower at 7,750 rpm. Its high-revving, high-compression design demands meticulous maintenance.

The S85 V10 Engine: Critical Considerations

The S85 V10 is a masterpiece of engineering but has several well-documented maintenance requirements that owners must respect:

• Rod Bearings: Premature rod bearing wear is the most well-known issue with the S85 engine. The factory clearances are tight, and many independent specialists recommend proactive replacement between 60,000–80,000 miles to prevent catastrophic engine failure .
• VANOS System: The variable valve timing system (VANOS) may require periodic inspection and replacement of solenoids and seals at higher mileages.
• Throttle Actuators: The electronic throttle actuators are a common failure point, often leading to "limp mode" on higher-mileage examples.
• Cooling System: Overhauling the water pump, thermostat, and hoses at regular intervals is essential to prevent overheating.

BMW Factory Maintenance Programs

BMW Ultimate Service

The 2009 BMW M6 included BMW's Ultimate Service program, which provided complimentary scheduled maintenance for 4 years or 50,000 miles from the vehicle's original in-service date . This coverage included engine oil and filter changes, brake fluid flushes, spark plug replacements, and vehicle checks.

Condition Based Service (CBS) System

The 2009 M6 also employs BMW's Condition Based Service (CBS) system. Sensors and algorithms monitor driving style, trip length, and component wear to calculate optimal service intervals. Service notifications appear on the Control Display when maintenance is due.

Scheduled Maintenance Intervals

The following intervals represent factory-specified maintenance for the 2009 BMW M6 . A conservative, preventive approach is strongly recommended for the S85 engine.

Engine Oil Service

Factory Guidance

The S85 V10 engine requires BMW-approved 10W-60 oil . This oil is critical for protecting the engine's bearings and valvetrain at extreme temperatures. The original factory-fill oil was Castrol TWS Motorsport 10W-60, now available as BMW M TwinPower Turbo 10W-60.

Engine Oil Capacity: Approximately 9.8 liters (9.3 quarts) with filter .

Conservative Owner Guidance

Motor oil is the single most important element in keeping the S85 engine healthy . While the CBS system may suggest longer intervals, Pelican Parts recommends changing the oil every 5,000 miles to minimize wear on the sensitive bearings .

Signs that an oil change may be needed sooner include:

• Check engine oil light is on
• Engine knocking sounds
• Oil smell inside the vehicle
• Excess amount of vehicle exhaust
• Frequent dusty road driving, heavy loads, or low-speed driving for long distances

Spark Plugs

Factory Guidance

The 2009 BMW M6's S85 V10 engine requires spark plug replacement at 37,000-mile intervals .

Number of Spark Plugs: 10 — one per cylinder.

Factory Replacement Schedule: 37,000 miles, 74,000 miles, 111,000 miles, 148,000 miles .

Genuine BMW Part Number: 12-12-0-032-273 .

Symptoms of Worn Spark Plugs

• "Engine Fault" codes that may seem intermittent
• Reduced performance
• Increased emissions
• Rough idle

Brake Service

Brake Inspection

BMW generally recommends that rear and front brakes be removed and serviced at least once every 12 months or 12,000 miles . This includes checking the parking brake.

Signs of brake problems include:

• Unusual sounds from the brakes
• Vibration or pulsation in the pedal or steering wheel
• Burning smell around the tires
• Dashboard brake light illuminated
• A sensation that braking performance has changed

Rod Bearings

Enthusiast Guidance

The S85 V10 engine has a well-documented vulnerability regarding its rod bearings. Due to tight factory clearances, rod bearings are a known wear item on the E60 M5 and E63/E64 M6 .

Independent specialists and aftermarket suppliers offer replacement bearings designed with extra clearance to address this flaw . Many enthusiasts consider rod bearing replacement a mandatory preventive service on higher-mileage S85 engines.

Symptoms of failing rod bearings include:

• Metallic knocking sounds from the engine, especially at cold start
• Metal particles in the oil filter
• Low oil pressure warnings

Frequently Asked Questions

Does the 2009 BMW M6 have a fixed maintenance schedule?

The 2009 M6 uses BMW's Condition Based Service (CBS) system, which monitors actual driving conditions to determine service intervals. However, a traditional mileage-based schedule is also provided for major items like spark plugs and the break-in service .

What engine is in the 2009 BMW M6?

The 2009 BMW M6 is powered by the S85B50 5.0L naturally aspirated V10 engine, producing 500 horsepower at 7,750 rpm.

What oil does the 2009 BMW M6 use?

The S85 V10 requires BMW-approved 10W-60 oil . Pelican Parts recommends changing the oil every 5,000 miles for optimal engine protection . The capacity is approximately 9.8 liters with filter .

How often should spark plugs be replaced on the 2009 BMW M6?

BMW recommends spark plug replacement every 37,000 miles . The engine requires 10 spark plugs, with Genuine BMW part number 12-12-0-032-273 .

Does the 2009 BMW M6 require a 1,200-mile break-in service?

Yes. The 1,200-mile break-in service is mandatory and includes engine oil, transmission fluid, and differential fluid replacement .

When should rod bearings be replaced on the S85 engine?

Rod bearings are a known wear item on the S85 V10 engine. Independent specialists recommend proactive replacement between 60,000 and 80,000 miles as a preventive measure .

When should oxygen sensors be replaced?

The factory schedule recommends oxygen sensor replacement at 120,000 miles .

How often should brakes be inspected?

BMW generally recommends that brakes be removed and serviced at least once every 12 months or 12,000 miles .

What is the engine code for the 2009 BMW M6?

The engine code for the 2009 BMW M6 is S85 .

What was the warranty coverage for the 2009 BMW M6?

The 2009 BMW M6 included a 4-year/50,000-mile new vehicle warranty and BMW Ultimate Service with 4 years/50,000 miles of complimentary scheduled maintenance .