2013 BMW X6 M: Maintenance Schedule & Service Intervals

The 2013 BMW X6 M (E71 generation) is a high-performance Sports Activity Coupe powered by the S63 4.4L twin-turbo V8 engine, producing 555 hp . As a full M model, it does not follow a traditional fixed-mileage schedule. Instead, BMW equips the vehicle with a Condition Based Service (CBS) system. Sensors and algorithms monitor driving style and conditions, determining maintenance requirements individually and displaying them on the Control Display. Service data is stored in the remote control for dealer reading . This schedule serves as a general guideline; always follow the CBS system in your vehicle and consult the Service and Warranty Information Booklet.

Key Takeaways

* The 2013 X6 M requires a mandatory 1,200-mile running-in service that includes an engine oil change, rear axle fluid change, and deactivation of the running-in check .

* BMW's maintenance guidelines are sensor-driven and center around the Condition Based Service (CBS) system, which typically cycles service every 10,000 miles .

* The S63 V8 engine requires BMW-approved synthetic oil, with an oil capacity of approximately 8.5 liters . RAVENOL 5W-30 meeting BMW Longlife-04 is suitable .

* Key service milestones for the 2013 X6 M include spark plug replacement every 30,000 miles and oxygen sensor replacement at 120,000 and 150,000 miles .

* Brake fluid must be replaced every 2 years using DOT4 specification fluid .

* The factory warranty included a 48-month/50,000-mile New Vehicle Limited Warranty and BMW Maintenance Program .

Understanding BMW's Condition Based Service (CBS)

The 2013 BMW X6 M does not follow a traditional fixed-mileage maintenance schedule. Instead, BMW equips the vehicle with a Condition Based Service (CBS) system that uses sensors and algorithms to monitor actual driving conditions and determine when maintenance is needed .

How the CBS system works:

• Sensors and special algorithms take into account the driving conditions of your vehicle to determine maintenance requirements .
• The system makes it possible to adapt the amount of maintenance you need to your user profile .
• Service requirements can be displayed on the vehicle's Control Display .
• Information on required maintenance is continuously stored in the remote control. Your service center will read out this data and suggest the right array of service procedures for your vehicle .

Important note: Storage periods during which the vehicle battery was disconnected are not taken into account. If this occurs, have a service center update the time-dependent maintenance procedures, such as checking brake fluid and, if necessary, changing the engine oil .

Critical: 1,200-Mile Running-In Service

The 2013 BMW X6 M, like all full M models, requires a mandatory running-in service at 1,200 miles. This service is critical for the long-term health of the S63 engine and drivetrain .

Items performed at 1,200 miles:

• Replace the engine oil and filter
• Replace the rear axle fluid
• Deactivate the running-in check using the diagnostic tool

Break-in driving guidelines :

• Up to 1,200 miles (2,000 km): Drive at varying engine and road speeds, but do not exceed 4,500 rpm and 100 mph (160 km/h). Avoid full-throttle operation and use of the transmission's kickdown mode.
• From 1,200 miles (2,000 km): The engine and vehicle speed can gradually be increased.

S63 Engine Specifications & Fluid Requirements

The 2013 X6 M is powered by the S63 4.4L twin-turbo V8 engine.

Engine Oil Specifications

The S63 engine requires BMW-approved synthetic motor oil. Motor oil is the single most important element in keeping your engine healthy. Always replace the oil filter when changing the oil. RAVENOL 5W-30 meeting BMW Longlife-04 is a suitable option .

Brake Fluid Specifications

The 2013 X6 M requires DOT4 specification brake fluid . Brake fluid is hygroscopic, meaning it absorbs moisture from the air over time. This can lower its boiling point and lead to corrosion inside the brake system, affecting braking performance and safety. BMW recommends brake fluid replacement every 2 years .

Spark Plug Specifications

The 2013 X6 M uses Genuine BMW spark plugs (part #12120057704) for the S63 engine . The engine requires 8 spark plugs for a complete replacement . BMW has recommended a 25,000-mile replacement interval for S63 spark plugs .

Factory Maintenance Schedule Overview

BMW's maintenance guidelines are sensor-driven and center around the CBS system. While the CBS system provides exact timing based on how you drive, the following framework outlines typical service milestones for the 2013 X6 M .

Frequently Asked Questions

1. How does the Condition Based Service (CBS) system work on the 2013 BMW X6 M?

The CBS system uses sensors and special algorithms to determine maintenance requirements based on actual driving conditions rather than fixed intervals. Service alerts appear on the Control Display when maintenance is due, and data is stored in the vehicle key for reading by a service center .

2. What type of oil does the 2013 BMW X6 M require?

The 2013 BMW X6 M requires BMW-approved synthetic motor oil. BMW Longlife-04 approved oil (such as 5W-30) is suitable . The oil capacity is approximately 8.5 liters. Always refer to the owner's manual for the specific viscosity required for your vehicle.

3. When should spark plugs be replaced on the 2013 BMW X6 M?

Firestone's maintenance schedule specifies spark plug replacement at 30,000-mile intervals for the 2013 X6 M . BMW has recommended a 25,000-mile replacement interval for S63 spark plugs . The S63 engine requires 8 spark plugs for a complete replacement.

4. How often should brake fluid be flushed?

BMW recommends brake fluid replacement every 2 years. The X6 M requires DOT4 specification brake fluid .

5. When should oxygen sensors be replaced on the 2013 BMW X6 M?

Oxygen sensors should be replaced at 120,000 miles and again at 150,000 miles to maintain fuel economy and minimize emissions .

6. What is the 1,200-mile running-in service for the 2013 BMW X6 M?

The 1,200-mile service is mandatory for full M models. It removes metal particulates from the engine and differential break-in process and deactivates the running-in check. During break-in, do not exceed 4,500 rpm and 100 mph (160 km/h) .

7. What is the engine oil capacity of the 2013 BMW X6 M?

The S63 4.4L engine requires approximately 8.5 liters of synthetic oil for a complete oil change with filter .

8. What was the warranty coverage on the 2013 BMW X6 M?

The vehicle included a 48-month/50,000-mile New Vehicle Limited Warranty and a 48-month/50,000-mile BMW Maintenance Program from the original in-service date . The vehicle also includes a service interval warning .